Well as you have probably already seen on the Intake and Exhaust forum that install didnt go as planned.... no good on the catback. the flange for a 2005 2.5 liter non-turbo'd engine is smaller than a 2002 turbo'd 2.0 liter.... im not entirely sure if this'll fit a 04-05 WRX or not as the bend is was also different on my 05 RS. kept hitting the heat shield.
It is a Pro 1 high performance catback. this thing sounds monsterous....watch this vid and have a listen.
Sabre (Julian) 92.5% Stock 04 STI
Good choice putting $4,000 rims on your 1990 Honda Civic. That's like Betty White going out and getting her tits done.
i just recieved an offer for 250. Since you are DCAWD you have the right to outbid i responded back sort of putting him on hold for the moment until you have time to consider.
It coudl work out perhaps where I could drive down to DC to drop this off as well as pick up the springs from will. Kill 2 birds with one stone
Last edited by Cereb Daithi on Thu Nov 09, 2006 1:56 am, edited 1 time in total.
I'd much rather sell this to a DCAWD member as I've had good dealings with members before and I'd much rather see it go to someone I can continue talking to
not that i can see. I havent done any serious testing on it but as far as i know the exhaust is solid. that small abcess is just from excess slag. my mechanic buddy took a look at it and wasnt concerned about it.
haha what's the most you can offer? the guy that wants it has NO member sales rating. and only 1 post... i dont trust him and like i said i'd rather it go to DCAWD
cheshirecat wrote:wife might grow horns and a tail....
Get pictures!!!!
Sabre (Julian) 92.5% Stock 04 STI
Good choice putting $4,000 rims on your 1990 Honda Civic. That's like Betty White going out and getting her tits done.
Sabre (Julian) 92.5% Stock 04 STI
Good choice putting $4,000 rims on your 1990 Honda Civic. That's like Betty White going out and getting her tits done.
I'll work on that.
