STi Corner splitters

Cereb Daithi · Post by **Cereb Daithi** » Mon Oct 16, 2006 3:59 pm

Well I have a set of corner splitters sitting in my garage. I really should put them on but im not entirely sure where to begin. i know i need ot buy a few of the plastic pins for the body-work to attatch..a nd i know i have to cut into the fender to attatch them...but other than that... any other suggestions? I dont want these things popping off at high speeds. should i be concerned with drilling some holes first? i think i have some sort of mounting bracket somewhere...but im not sure where to put them... i know the actual STis have little holes that small tiny pins go through..but the pins have been broken off.

sigh. or should i just pay someone to put them on for me

Post by **Sabre** » Mon Oct 16, 2006 4:38 pm

Just remember: Measure twice, cut once.... say it with me... Measure twice, cut once...

Oh and take pictures!

sirwilliam · Post by **sirwilliam** » Mon Oct 16, 2006 4:39 pm

sabre wrote:Just remember: Measure twice, cut once.... say it with me... Measure twice, cut once...

Oh and take pictures!

Measure twice, cut once....Measure once, cut twice....Measure once, cut thrice....