DCAWD.com

Posted: **Tue Jan 24, 2006 10:13 pm**

I purchased a used APEXI white faced 60mm mechanical boost gauge over a year ago. Well, I recently noticed that the needle was sitting at 1psi unattached.

This means that I have a nice faulty gauge or is there a way to adjust it?

I guess I could check the boost readings and just see if it is just off by 1 psi which I can live with. I hate to loose the gauge b/c it is one of the better looking boost gauges out there.

Posted: **Tue Jan 24, 2006 10:14 pm**

are you at sea level?

sorry, couldn't resist.

Posted: **Tue Jan 24, 2006 10:23 pm**

Mr Kleen wrote:are you at sea level? sorry, couldn't resist.

Not sure...I will go check

Posted: **Tue Jan 24, 2006 10:39 pm**

Chances are it might be fuggered.

*crosses fingers for teh will*

Posted: **Tue Jan 24, 2006 10:52 pm**

bluscooby23 wrote:Chances are it might be fuggered.

*crosses fingers for teh will*

Thanks man...hopefully it isn't fugged 'cause that would suck. Guess there is only one way to find out.

Posted: **Tue Jan 24, 2006 10:59 pm**

I will verify the boost gauge w/ a comparison to my AP's realtime boost function.

DCAWD.com

Boost gauge...

Boost gauge...