DCAWD.com

Hello Everyone. Does anyone happen to be available on the 28th to install a set of headers, UP, and TBE? I think I have everything I need to install my exhaust goodies. I am one hose clamp away from being done wrapping the UP, and I've already wrapped the headers and DP. I have the gaskets, longer exhaust hangers, and new heat shield too. Does anyone have an O2 sensor socket I could temporarily borrow? I was thinking Fort Myers again, but I'm flexible with the location. Thank you!!!!!

Hey dude, I'm not sure if I'm going to be available on the 28th yet or not. I do have an O2 socket that I'll bring to the meet on Tuesday.

Awesome!!! Thank you so much!


I'm also free the weekend of the 17th and 24th of April if that works any better.

Sorry man, I'll be in Mexico. You've helped me a few times so I owe ya.

i'd *love* to help on this. it's been a few months since i did any wrenching. can't do the 28th though.

27/28th I'll be in Richmond I might be able to do the 24th, but prefer the 17th.

Out of town. But I would love to get my hands dirty sometime. I have to replace my cat and axle back...

zaxrex wrote:Out of town. But I would love to get my hands dirty sometime. I have to replace my cat and axle back...

count me in if you need a hand

Mr Kleen wrote:Sorry man, I'll be in Mexico. You've helped me a few times so I owe ya.

You don't owe me anything. I was enjoying helping out and turning a wrench.



Thank you for all the help! Well, how about the 17th of April then? Zak, if you are available, we can do your exhaust too. It shouldn't take too long.

My EGT bung plug popped off last night, so I dove in and started on the project. Looks like it was sooner that I had anticipated, thanks for the offer of hands and location.

I'd show up on the 17th, if I don't get called away. Besides, my taxes should be done by then, right?

As in the bung came off the UP or just the sensor popped out? lol, I had a bung pop off of my UP once during turning!

Nah, just the bolt to plug it. The weld is true.

We are going to do a bday celebration for my Dad on the night of the 17th. Would anyone happen to be available next Sunday, the 11th or the following weekend, the 18th? Thank you again!

I might be able to do either - let me check my schedule(r).

The following weekend (18th) works best for me, but if you get time to do it next weekend, by all means go for it

Looks like I have to work on the morning of the 18th... Would 1 pm be too late of a time to start on the 18th? I don't have anything planned for the 25th, if that would work better. Thanks again for the help.

Work on a Sunday? Booooo! I'm 90% in

Sweet! Yeah, we have to do our monthly maintenance. Our window is from 6 am - 11 am on Sundays...

Do you guys still happen to be available for this Sunday?

yep

maybe... I'll do my best to help out for at least a few hours.

Pretty sure I can do at least part of the day.

When/where again pls? PM is fine.

Out of town.

Sorry

Awesome! Thank you so much. If you don't mind, I would like to do it at my place. That way, everyone can come and go as needed, and I can finish up the install during the week if it gets too late. I have to work that morning, but we will be done my 11 am. So, I'm thinking 1 pm? Does that work for everyone? I can PM my address too. Thank you again!

I may be able to help out.
Add me to the PM list.
Do you have a rubber mallet? It's necessary for the headers
If not I can bring mine.