...and put on my supporting mods before spring install. This was done right after work yesterday. I decided my XT sat high enough that I didn't need to go up on my rhino ramps or jack up the car. I installed the following:
-STi 20mm RSB w/ larger mounts
-KB rear endlinks
-MoBoost LLWS
Here is a pick from Peaty (scoobymods) that has the same setup and it looks identical to: SCOOBYMODS PIC LINKY
You can see in the picture why the MoBoost supports (the black pieces) are needed due to the crappy weld on the rear lateral link tabs.
Hopefully, get the springs on this week...then maybe my F&R strut tower bars and then my new 18 RPF1s!
NOTE: After using my torque wrench to tighten up the bolts w/ absolutely no room/clearance, I decided next time to use rhino ramps
Got off my lazy @$$...
Moderator: Moderators
- sirwilliam
- Resident Poop Expert
- Posts: 7226
- Joined: Mon Aug 01, 2005 1:27 pm
- Location: The Wild Serengeti Suburbs
Got off my lazy @$$...
2004 SG Model A PearlBlackObsidian (RIP)
2008 SG Model D BlueRallyWorld
"When I get sad, I stop being sad and be awesome instead. True story." -Barney Stinson
"Nothing shuts my pie-hole but pie." -Shawn Spencer
2008 SG Model D BlueRallyWorld
"When I get sad, I stop being sad and be awesome instead. True story." -Barney Stinson
"Nothing shuts my pie-hole but pie." -Shawn Spencer