Page 1 of 1
Neoprene rubber for custom mod to GT Spec splitter
Posted: Fri Jul 07, 2006 9:24 am
by sirwilliam
Think I will be going w/ this to make a good seal for the new TMIC:
http://tinyurl.com/k66h8
What do you guys think? Looks pretty decent to me.
Posted: Fri Jul 07, 2006 11:26 am
by zaxrex
that is wetsuit material. If you can find some wat to affix it to the splitter, it will help fill the gap. Over time, the rubber will get dried out and cracky, but you will have extra of it and can do it again.
Posted: Fri Jul 07, 2006 12:58 pm
by sirwilliam
zaxrex wrote:that is wetsuit material. If you can find some wat to affix it to the splitter, it will help fill the gap. Over time, the rubber will get dried out and cracky, but you will have extra of it and can do it again.
Word! thanks.
Posted: Fri Jul 07, 2006 3:34 pm
by drwrx
Be very careful. I have tried several rubber seals for my STi splitter and my big ebay TMIC and all of them melted to some degree (some worse than others. I have since removed all of it except the seal on the front.