But who F'ing cares, this is just plain automotive art wickedness.
Forget the engine and car (well, OK, I'd have them both), gimme the velocity stacks and water injection!
http://www.fluidmotorunion.com/archives/7892
Made entirely from 6061-grade aluminum, this new velocity stack set for the E9x M3 was conceived, designed, cut out and assembled in-house at Fluid MotorUnion. Our system incorporates an Aquamist (care of Howerton Engineering) water-methanol injection system, which runs from the tank in the back to a specially-designed manifold that splits up the 6mm inlet to eight 4mm direct-injection nozzles, which are placed at the ends of the arms that stretch over each individual stack. The tubing from the manifold to the nozzles, just like on the DCM3, are fed through specific channels in the arms themselves. When all’s said and done, it looks like the grim reaper’s put his special touch on this system.